Print to File sends the printer output to a file rather than directly to the printer. Set Print Filename to specify the destination file.
Cancel Print on Error terminates the print process if an error occurs.
Display Setup Dialog invokes the Print Setup dialog box if it was not previously invoked. The dialog box determines the target printer and printer properties.
Determines the number of points to plot for a series when more than one
point will plot to the same printer X location.
| None | Plot all the points without regard for the actual printer resolution. |
| Automatic | Decimate the plot based on the actual printer resolution. The resolution for most printers is normally higher than the screen resolution. |
Specifies the size adjustments when printing in portrait mode.
| None | No adjustments. |
| Height and Width | Adjust the plot to have the same aspect ratio as landscape mode. |
| Height Only | Adjust the height to the page maximum. |
Sets the default aspect of the output plot. The orientation can also be specified
with the Print Setup dialog box.
| Landscape | Sets the width to be the longest dimension. |
| Portrait | Sets the height to be the longest dimension. |
The destination file when Print to File is checked.
Sets the X and Y coordinate scaling, line width multiplier, font scaling and
border line width.
| X Dimension | The horizontal dimension. Automatic obtains the horizontal dimension directly from the printer. Recommended. | Y Dimension | The vertical dimension. Automatic obtains the vertical dimension directly from the printer. Recommended. |
| Line Width | Sets the line width multiplier for all drawn lines. Useful when the default line width for the printer is too thin. A multiplier of N increases the line width by a factor of N. A multiplier of 1 implies no adjustment. |
| Font Scaling | The percentage increase or decrease of all font sizes. A scaling of 100% implies no adjustment. |
| Border Width | The line width multiplier for the outer border only. |