DADiSP 6.5 B05 Release Notes
Using the SPL Debugger
commands start the SPL debugger
and set a breakpoint in the specified function.
For example, following debug session:
invokes the SPL Debugger and sets a breakpoint in the
function. The Command Line will display a red
prompt background to indicate debug mode.
Since the roots
function is called, the debugger will
display the source code and pause at the first executable line. Use
the GUI interface to step through code, set breakpoints and evaluate
expressions. Click on any variable to display its value.
Because a breakpoint has been set in the roots
function, the debugger
will pause whenever roots
is called. For example, invoking
function through the pull down menus:
Analysis » Signal Processing » Partial Fraction Expansion
causes the debugger to stop in roots
Use the appropriate debugger buttons to step through and into SPL
functions, move up and down the stack and show the function call
Use the debugger command prompt to examine global and local
variables by entering the variable to examine or simply click on
any variable to view its current value in the output display
Press the Breakpoints button or use the db
function to set
additional break points in SPL routines and to set a break point
at a specific line number.
Clicking the left mouse button in the left
margin of a line also sets a new breakpoint or clears an existing breakpoint.